MightyFrame PROM Version 1.3
available memory:0x500000 mapped as:F1
memory frames 100 - 200 not present
memory frames 200 - 300 not present
memory frames 300 - 400 not present
tape status:810000 RESET
tape status:0
checking tape for dump area
tape status:81000000 FMFOUND
CTIX was not running - no dump needed
checking memory at 400000 [ addr ~addr parity ]
checking memory at 500000 [ addr ~addr parity ]
checking memory at 600000 [ addr ~addr parity ]
checking memory at 700000 [ addr ~addr parity ]
tape status:0
tape status:0
tape status:81000000 FMFOUND
executing loader from tape

MightyFrame I loader version 12
booting from tape



MIGHTYFRAME MC68020 CTIX KERNEL DEBUGGER V2.0


COPYRIGHT 1983,1984,1985,1986 BY CONVERGENT TECHNOLOGIES.



CTIX/S5.2.2: CTIX raw
Maximum user process size:0x1780000 bytes
Maximum processes:50
Maximum regions:150
Maximum open files:60
Maximum open files per process:20
Maximum open inodes:40
Floating Point Chip-68881 present
VME bus interface board is not present
RS422 board is not present
Terminal Accelerator board is present
Ethernet Combo board in slot 2 configured for dma slot 0
28 Serial Ports in system
Number of clists:58
avail mem = 4554752
VME interface board not present on smd controller 1 drive 0, slice 0
                ***********************************************
                *                                             *
                *                                             *
                *        WELCOME TO MIGHTYFRAME CTIX          *
                *                                             *
                *                                             *
                *   This is the software raw install tape     *
                *                                             *
                *   It should be used ONLY for new systems    *
                *                                             *
                *   IT WILL OVERWRITE AND DESTROY THE ENTIRE  *
                *                                             *
                *   CONTENTS OF YOUR DISK DRIVE               *
                *                                             *
                *   Hit the <delete> or interrupt key on your *
                *                                             *
                *   terminal to enter maintenance mode.       *
                *                                             *
                ***********************************************




You have an onboard ST506 drive 0.
Do you wish to continue and install the CTIX software on
        ST506 drive 0 ? Type 'yes' to confirm/continue:  no
Aborting Installation
If you wish to install over an existing CTIX release
Remove this tape and reset the MightyFrame
Then proceed as documented in the release notice